And install the driver downloaded recently... To do this, connect your i-Drive device and in the Device Manager look for "Other devices" expand it (if its not) and right click over "Unknown Device". If you have more than one Unknown Device see not below.
Atmel At91 Usb Driver 13
Good work.. =D.. The pin mapping in ASF is kinda strange.. If you want, you can post your code and the board type you chose in atmel studio and I'll look into it.. But I'm sure that you can manage to figure it out on your own..
[HKEY_LOCAL_MACHINE\Drivers\USB\FunctionDrivers\Serial_Class] "Dll"="serialusbfn.dll" "DeviceName"="USBFNS1:" "Prefix"="COM" "DeviceArrayIndex"=dword:0 "RxBufferSize"=dword:4000 "IClass"="CC5195AC-BA49-48a0-BE17-DF6D1B0173DD" "idVendor"=dword:03EB "Manufacturer"="Atmel Manufactor" "idProduct"=dword:6119 "Product"="at91sam9261-ek" "bcdDevice"=dword:0 "Tsp"="Unimodem.dll" "DeviceType"=dword:0 [HKEY_LOCAL_MACHINE\Drivers\USB\FunctionDrivers\Serial_Class] "Index"=dword:4 "FriendlyName"="USB Cable Connection" [HKEY_LOCAL_MACHINE\Drivers\USB\FunctionDrivers\USBSER_Class] "Dll"="serialusbfn.dll" "DeviceName"="USBFNS2:" "Prefix"="COM" "DeviceArrayIndex"=dword:1 "RxBufferSize"=dword:4000 "IClass"=multi_sz:"CC5195AC-BA49-48a0-BE17-DF6D1B0173DD","C375C787-B721-4b8e-B67F-A112D5C0A404" "idVendor"=dword:03EB "Manufacturer"="Atmel Manufactor" "idProduct"=dword:6119 "Product"="At91sam9261-ek" "bcdDevice"=dword:90 "Tsp"="Unimodem.dll" "DeviceType"=dword:0 [HKEY_LOCAL_MACHINE\Drivers\USB\FunctionDrivers] "DefaultClientDriver"=- ; erase previous default [HKEY_LOCAL_MACHINE\Drivers\USB\FunctionDrivers] "DefaultClientDriver"="Serial_Class" On the board I can open the "virtual" serial port (I see it as COM4) and read/write on it.I attached the usb cable to a Linux Host PC with: modprobe usbserial vendor=0x03EB product=0x6119 2ff7e9595c
Comments